CFMoto CForce G3 Belt Temp Resistor

CFMoto CForce G3 850-1000 

Belt temp resistor DIY FIX, for Gen3 CFORCE and GOES TERROX with belt temperature sensor.

This is easy solution to get full HP all the time!

Under the secondary clutch (gen3 CForce and GOES TERROX), you can find the belt sensor. It's monitoring the out coming cooling air from cvt and by that ECU is controlling HP and preventing belt to get damaged if temperature is getting too hot.

Until the belt gets to operating temperature to 50 celsius / 120 fahrenheit. It will reduce engine horsepower (you can see this at dyno and it's taking 5hp out from wheel at peak hp and lower whole powerband)

And if the Belt get over 70 Celsius / 160 Fahrenheit it will start to reduce engine power again.
(And the total drop is about 8hp from at wheel in dyno and the whole powerband is lower.)

The optimal operating temperature for belt is 50 Celsius /120 Fahrenheit to 70 Celsius/ Fahrenheit 
And usually it will be there but in Sken and Racing use it can go to 80-90 Celsius and that is killing your engine HP!

This easy solution will give same 60° reading all the time and you get all out of your engine!

This is DIY solution and may need little technical knowledge.